|
|
|
| Seal Proof Engineering |
| Manufactures of High Quality Mechanical Shaft Seals |
|
|
|
|
| Quality Control |
|
|
|
Seal Proof Engineering follow "Best PRODUCTS, Better SERVICE, On TIME, Every TIME. "
Seal Proof believes in total quality systems. We strictly follow the standards BS, ASME, API. We believe that the service provided to the customer can be of the first quality only when the procedure laid then by the company is strictly followed at all the stages from the beginning.
We have quality skilled and experienced manpower for erection and fabrication process.
The quality system that we adhere at the following stages:
Welders qualification:
All welders are given the nos. like W3, W4, etc. A separate register is maintained for WPS & PQR. Both WPS & PQR are prepared in the printed format & after the successful qualification these records are endorsed by the third party inspector. A separate file is maintained for these records.
Stage-wise inspection:
The in-process stages like set-ups, back chips, fit-ups etc are recorded with all the observations in the stage-wise inspection report book before offering the same to the third inspector.
Radiography:
A radiography sketch of the equipment giving details of all the weld joints is prepared in advance & after the radiography is taken they are marked in the sketch. The radiography technique, the source strength, the film details and the joint details. After the films are viewed the remarks are entered & then offered fir the third party inspector for his review.
Dimensional inspection:
When the equipment is completed in all aspects before hydro test the final dimensions are checked & noted on the drawing as well as a report is prepared. Any major deviation observed are corrected, if not possible, conveyed to the client/consultant for their approval.
Hydro test:
Hydro test is carried out on the equipment after all the clearances are obtained for NDT, dimensional, materials etc. The equipment is positioned in such way so that no airlock is created. Two pressure gauges are used which are calibrated. All the weld joints as well as the joints are thoroughly cleaned. Holding time is minimum of 30 minutes. A separate Inspection report is prepared & enclosed by the third party Inspector.
.
|
| | | Contact Details | | | | Seal Proof Engineering
Mr J. R. Salema / Mr. Rizwan Salema
218, Vinay Heavy Indl. Estate, Chincholi Bunder, New Link Road, Malad -w
Mumbai - 400064
Maharashtra, India
Tel. No. : 91-22-67030881 / 9820596261
Fax No. : 91-22-28731461
 Send Trade Inquiry | | | |
|
| Quality Control of Seal Proof Engineering |
|
|
|
|
